462624 head casting any good?
Thread Starter
Junior Member
Joined: Dec 2006
Posts: 38
Likes: 0
From: Kentucky
Car: 89 Iroc Z
Engine: Gen 1 350
Transmission: 700r4
Axle/Gears: Stock and shitty
462624 head casting any good?
are these heads worth a ****? do they flow well i cnat find and flow specs or anything ont hem really i beleice it has 194 150 valves
Joined: Aug 2006
Posts: 12,812
Likes: 110
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: 462624 head casting any good?
if im remembering the #'s correctly, 76cc crack prone and crap
Joined: Sep 2005
Posts: 27,996
Likes: 2,485
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: 462624 head casting any good?
Right; they are among the very worst.
1.94" / 1.50" is the stock valve sizes for the majority of 350 heads. Nothing special about that at all.
They can be made to flow OK, they can even have 2.02" intakes and 1.6" exhausts installed in them. However, one of the things that a flow bench WON'T tell you, is that they'll crack between the valve seats if you enlarge the valves (they're bad enough about that with what comes in them). Furthermore, there's some places that get REAL thin in the exhaust ports, that will also crack if they're ported.
They are trash. Throw them there and get something decent.
1.94" / 1.50" is the stock valve sizes for the majority of 350 heads. Nothing special about that at all.
They can be made to flow OK, they can even have 2.02" intakes and 1.6" exhausts installed in them. However, one of the things that a flow bench WON'T tell you, is that they'll crack between the valve seats if you enlarge the valves (they're bad enough about that with what comes in them). Furthermore, there's some places that get REAL thin in the exhaust ports, that will also crack if they're ported.
They are trash. Throw them there and get something decent.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
Aug 23, 2015 11:49 AM
