My car is not getting spark and im not sure why. The car was running and stalling and I fixed that problem (temporarily) because the three wire connector that goes into the distibutor cap was not making a good connection. So then it started stalling again. This time I cut the three wire connector off and put on another one that I had on. However, I mixed up the brown and black wires on it by accident. Now I have the black to the black and the brown to the brown again. Could this have caused any damage anywhere? Is that what I should look into for my no spark problem?

 

coil, thats what happened to me. dizzy cap and rotor, electronic control module, burned wires

 

So your saying my coil is bad now?

 

Found the problem. It turned out to be that the white wire to the coil was broken.