Need help with distributor wiring..
Thread Starter
Junior Member
Joined: Feb 2009
Posts: 31
Likes: 0
From: Phoenix Arizona
Car: 88 IROC-z "Deathtrap"
Engine: 355 SBC
Transmission: T-5 stage2 Clutch
Axle/Gears: 3.08 Std (Taking a hike)
Need help with distributor wiring..
So i had a 305 TBi and i yanked it. Loaded in a 355 sbc with a Holley 750 and a GM HEI distributor with a Mallory coil and Curve kit. I don't know anything about the distributor, the Mallory stuff. But my real question is this: How do i wire it up for the tach and the battery? I see there is little printed letters that say (+) BATT - Grnd - COIL (-). Anybody got any ideas? Thanks i appreciate it...
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
The pink wire that went to your original coil goes to BATT. The white wire that went to your original coil goes to TACH.
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM
HoosierinWA
Tech / General Engine
5
Oct 7, 2015 10:15 AM
Damon
Tech / General Engine
8
Sep 26, 2015 04:29 PM
