fuel tk
#1
Junior Member
Thread Starter
Join Date: Nov 2009
Location: Clarksville, TN
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 GTA / G8 GT
Engine: 5.7L / 6.0L
Transmission: auto's :(
fuel tk
I'm trying to stop a very small leak for the second time. The first time I was just lazy and didn't clean the area well enough. It's on bottom of the tank on the right hand side just above the trac bar. This time I cleaned it with carb cleaner and scuffed it a little with some sandpaper. It's a very small crack width of a fingernail and about 3/8". It really just sweats when it hits bumps but with a full tank it sweats pretty badly from the weight. If the second time doesn't work any recommendations what to use for the 3rd. I used an epoxy from advance auto that you just knead until warm then stick it on. I'm leaning toward JB Weld.
Thread
Thread Starter
Forum
Replies
Last Post
beachrodder
Tech / General Engine
7
08-25-2015 08:05 AM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM