113 Aluminum Heads swap and cam-swap started
Thread Starter
Member
iTrader: (16)
Joined: Dec 2006
Posts: 469
Likes: 1
From: TX/FL
Car: 88 GTA/86 C20 Burb/91 325i
Engine: L98/454/M20
Transmission: 700R4/NV4500/Getrag
Axle/Gears: 3.27 9-bolt/3.73 14 Bolt/3.73 IRS
113 Aluminum Heads swap and cam-swap started
Hey all,
I won't retype it all right here, but I started my motor build up this weekend, and I had some useful information on my steps and combination. Here's what's been done/in the works for the engine:
Corvette 113 Aluminum Heads
CompCams XR258-HR12 cam, new lifters, timing chain, etc
new oil pump, seals, etc.
Weiand Street Warrior intake
Shorty headers
HEI Igntion and non-CCC quadrajet w/ heat shield
some other odds and ends
If you want to take a look, the whole build thread is here, it's on the 1st page:
https://www.thirdgen.org/forums/hist...engineers.html
Enjoy,
-Levi
I won't retype it all right here, but I started my motor build up this weekend, and I had some useful information on my steps and combination. Here's what's been done/in the works for the engine:
Corvette 113 Aluminum Heads
CompCams XR258-HR12 cam, new lifters, timing chain, etc
new oil pump, seals, etc.
Weiand Street Warrior intake
Shorty headers
HEI Igntion and non-CCC quadrajet w/ heat shield
some other odds and ends
If you want to take a look, the whole build thread is here, it's on the 1st page:
https://www.thirdgen.org/forums/hist...engineers.html
Enjoy,
-Levi
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
