Polylock Torque methods
Thread Starter
Member
Joined: Nov 2008
Posts: 124
Likes: 0
From: springfield OR
Car: 85 Z28 scca C Prepared
Engine: 5.7 348 RWHP
Transmission: t5
Axle/Gears: dana 44 3.41
Polylock Torque methods
Got some AFR polylocks w/ stud girdles any ideas on method, set screw alone or back the nut up 1/8th of a turn and jam both at once. Torque Spec?
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: Polylock Torque methods
Turn both at once. You'll never get enough torque on the set screw alone to get it to hold.
Joined: Dec 2005
Posts: 6,499
Likes: 31
From: Macon, GA
Car: 1992 Camaro RS
Engine: Vortec headed 355, xe262
Transmission: T56
Axle/Gears: 9-bolt 3.70
Re: Polylock Torque methods
Yeah I just tighten the lock, and then tighten the nut again... it wont move far, dont hoss down on it after that, just make sure it's snug.
Thread
Thread Starter
Forum
Replies
Last Post
no green
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 9, 2016 09:22 PM
