Another dead Fuel Pump
Thread Starter
Member
Joined: Dec 2005
Posts: 443
Likes: 2
From: Wild Blue Yonder
Car: 1991 RS Camaro
Engine: 350 TBI
Transmission: 700R4
Axle/Gears: 3.42 Posi
Another dead Fuel Pump
So, after having the Walbro 255 for 6 years I'm pretty sure its dead. Before dropping the rear again to get to it I'm not sure what I should replace it with. I'm looking for any suggestions. Looking for a good pump which will support future mods & engines and hopefully last longer so I'm not doing this again in a few years.
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
What future mods do you have in mind?
A Walbro 255 is feeding my 12-sec LS1 just fine.
A Walbro 255 is feeding my 12-sec LS1 just fine.
Thread Starter
Member
Joined: Dec 2005
Posts: 443
Likes: 2
From: Wild Blue Yonder
Car: 1991 RS Camaro
Engine: 350 TBI
Transmission: 700R4
Axle/Gears: 3.42 Posi
Re: Another dead Fuel Pump
In the future I'm headed towards a cammed Vortec 350 with TBI on top with an EBL for tuning. I'll probably play with the 305 some more before then.
Thread Starter
Member
Joined: Dec 2005
Posts: 443
Likes: 2
From: Wild Blue Yonder
Car: 1991 RS Camaro
Engine: 350 TBI
Transmission: 700R4
Axle/Gears: 3.42 Posi
Re: Another dead Fuel Pump
I have also heard the Walbro 255 is a but too much and will only be overworking itself. I'm just curious what else people are using other than Walbro or TPI pumps. I think Holley has one too if i'm correct.
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
