Code 24, but has brand new VSS?
Thread Starter
Senior Member
iTrader: (1)
Joined: Mar 2004
Posts: 584
Likes: 3
From: Metter, Ga
Car: 1992 Camaro z28
Engine: 350 HSR
Transmission: 700R4
Axle/Gears: 3.42's
Code 24, but has brand new VSS?
My speedo has worked on and off for the past half year, no codes or anything over that time. I just bought a new sensor for it last week since I rebuilt the trans and figured I might as well fix that too. Now im getting a code 24(VSS sensor) when driving, wtf? The speedo hasn't even tried to work since putting the new sensor inn though.
What would you guy recommend checking first? The wires at the connection on the trans looked alittle kinked so i replaced that section.
What would you guy recommend checking first? The wires at the connection on the trans looked alittle kinked so i replaced that section.
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 231
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Re: Code 24, but has brand new VSS?
Pull the VSS and check the gear on it. If it is stripped then the gear on the output shaft is likely in the wrong location. One location is for y-body's while the other location is for f-body's. they each use a different tail housing.
It also may be that the retainer clip on the output shaft isn't holding the gear.
RBob.
It also may be that the retainer clip on the output shaft isn't holding the gear.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
MikkoV
TPI
2
Sep 9, 2015 04:25 PM
UltRoadWarrior9
Transmissions and Drivetrain
3
Sep 2, 2015 08:24 PM
