Back to a no start. Just click
Thread Starter
Member
Joined: May 2012
Posts: 120
Likes: 0
Car: 1986 t/a
Engine: Lg4 305 carb
Transmission: 700r4 auto
Axle/Gears: 2.73 posi
Back to a no start. Just click
Hey starter problem again, so far ign switch, NSS, Batt cables, Batt, starter and solenoid. Car was starting great, running fine. Came out other day went to start. Got the (cha click) and won't start.
Turning key million times started once. Shut it off no more start!
Climbed under it with screwdriver jumped solenoid and starter spins..
Wires all new. Grounds all cleaned, tight.
Would it be bad solenoid??
Turning key million times started once. Shut it off no more start!
Climbed under it with screwdriver jumped solenoid and starter spins..
Wires all new. Grounds all cleaned, tight.
Would it be bad solenoid??
Supreme Member
Joined: Jan 2012
Posts: 2,027
Likes: 33
From: Washington State
Car: 1983 BB 1995 Z28 Camaro's
Engine: 454-350
Transmission: TH350-4l60e
Axle/Gears: 373 posi-Stock
Re: Back to a no start. Just click
If starter spins but does not come out to engage ring gear it is most likely the solenoid IMO
Thread Starter
Member
Joined: May 2012
Posts: 120
Likes: 0
Car: 1986 t/a
Engine: Lg4 305 carb
Transmission: 700r4 auto
Axle/Gears: 2.73 posi
Re: Back to a no start. Just click
I found the problem. Housing to the solenoid was cracked,
I might have over tightened (dumb*#%)
Anyways put another one on. I roll once again!!!
I might have over tightened (dumb*#%)
Anyways put another one on. I roll once again!!!
Supreme Member
Joined: Jan 2012
Posts: 2,027
Likes: 33
From: Washington State
Car: 1983 BB 1995 Z28 Camaro's
Engine: 454-350
Transmission: TH350-4l60e
Axle/Gears: 373 posi-Stock
Re: Back to a no start. Just click
Those parts are made cheap to bad the prices are not the same good luck.
Thread
Thread Starter
Forum
Replies
Last Post
