so i got this crap 350 crate from Jegs for free (gift), and im building it. I plan on upgrading the heads, cam, timing chain, oil pump for a larger pan, full exhaust and possibly a power adder. the heads right now are cast iron 76CC goodwrench. and the cam is a hydraulic flat tappet. any recommendations on heads? I got 3500$ from insurance due to an accident, and I'm trying to sell the stock heads right now. thanks alot

 

U wont sell those crap heads for anything better off let them go to the scrap or just collect rust an dust. I would look into either aluminun heads or a nice set of vortec heads off a later 350 truck the 906 vortec could flow good numbers but u cant use a big lift cam on them

 

i think it was car craft that just did a mail order heads shoootout for under a thousand bux. check out the article. they compared 8 different heads

 

Hop up on same GM crate engine
Summary
http://www.chevyhiperformance.com/te...ne_build_viii/

http://www.chevyhiperformance.com/te...gine_build_ii/
http://www.chevyhiperformance.com/te...ine_build_iii/
http://www.chevyhiperformance.com/te...gine_build_iv/

 

Jegs 180-195 cc brand heads or go patriot 185's for budget head. Cam it up to match the head and run a good dual plane intake. Should be an easy 400-450hp with a 268 type cam

 

if i get those L98 heads, can i run a weiand 144 or 147 supercharger and a 4bbl carb or is not compatible with the heads