Vortec head gasket question
Thread Starter
Member
Joined: Mar 2000
Posts: 409
Likes: 0
From: Land O Lakes, FL
Engine: 5.7
Transmission: 700R4
Axle/Gears: 3.27
Vortec head gasket question
Swapping stock heads for a vortec set on L98 block. I'm using Felpro 1094 head gaskets and the instructions mention requiring a special block/head finish for them to seal properly.
I'm trying to decide if I should just put them on as is or spray them with sealant before putting them on?
If sealant what kind of sealant? I need a quick answer and thanks.
I'm trying to decide if I should just put them on as is or spray them with sealant before putting them on?
If sealant what kind of sealant? I need a quick answer and thanks.
Member
Joined: Jan 2012
Posts: 294
Likes: 0
From: Milwaukee
Car: 1984 Z28
Engine: Vortec 350, hotcam
Transmission: T56
Axle/Gears: 3.73
Re: Vortec head gasket question
Most of the time I hear about people spraying them with "copper spray." Something like this
http://www.summitracing.com/parts/sce-g1612
http://www.summitracing.com/parts/sce-g1612
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
NinjaNife
Tech / General Engine
27
Aug 23, 2015 11:49 AM
84z96L31vortec
North East Region
1
Aug 10, 2015 08:27 PM
