MOROSO CRANKCASE EVACUATION KIT
Thread Starter
Member
Joined: Jun 2001
Posts: 397
Likes: 11
From: new york , n.y. , USA
Car: klowny1969 <-youtube 4 3rd gen vids
Engine: subscribe to klowny1969 on youtube!
Transmission: subscribe to my channel on youtube
MOROSO CRANKCASE EVACUATION KIT
I put Moroso's evac kit to the test on my 91 camaro.... Enjoy
Supreme Member
iTrader: (1)
Joined: Nov 2003
Posts: 1,598
Likes: 2
From: Davenport, Iowa
Car: Still a 3rd Gen
Engine: 450HP 355
Transmission: TH350
Axle/Gears: 9" with 4.11's
Re: MOROSO CRANKCASE EVACUATION KIT
I had similar results, slightly less under load. (not sure where you pulled your signal from though)
I used a 2 bar MAP sensor hooked up to the oil cap, logged by an extra input on my computer. With 2 slash cuts pulling off of longtubes, open cutouts i had a little less than 1" or so of vacuum at WOT in the crank case. At idle it bounced all over the place like yours did.
Old school tech, works good if you don't mind blowing some smoke out of your exhaust.
I used a 2 bar MAP sensor hooked up to the oil cap, logged by an extra input on my computer. With 2 slash cuts pulling off of longtubes, open cutouts i had a little less than 1" or so of vacuum at WOT in the crank case. At idle it bounced all over the place like yours did.
Old school tech, works good if you don't mind blowing some smoke out of your exhaust.
Thread Starter
Member
Joined: Jun 2001
Posts: 397
Likes: 11
From: new york , n.y. , USA
Car: klowny1969 <-youtube 4 3rd gen vids
Engine: subscribe to klowny1969 on youtube!
Transmission: subscribe to my channel on youtube
Re: MOROSO CRANKCASE EVACUATION KIT
kool thanks for the verification of my findings lol Nowhere on youtube you can find anybody else testing the evac kit, so i figured i'd make a video..
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
1
Jan 15, 2016 06:26 AM
1Aauto
Sponsored Vendors
0
Sep 2, 2015 01:35 PM
