has anyone used these wires?
MSD-31409
how do they fit?
are they like banjo strings like the Accel 8.8's are for the TPI?
I have the 8.8's and they are extremly tight fitting, hardly any room to run wire sperators
I want to neatly lay the wires out and would like to use wire separators as well
what separators can i use with these wires? is there a spearator that bolts to the center valve cover bolts?
I also have 89 Full Size 5.7 TBI Chevy Blazer wires from MSD (brand new), was wondering if i could just use them?
they are 90 degree boots on them
the trucks used manifolds that went downward, the F-bodies used an upward manifold, so not sure if these would fit without rubbing/burning somewhere.
thoughts?
MSD-31409
how do they fit?
are they like banjo strings like the Accel 8.8's are for the TPI?
I have the 8.8's and they are extremly tight fitting, hardly any room to run wire sperators
I want to neatly lay the wires out and would like to use wire separators as well
what separators can i use with these wires? is there a spearator that bolts to the center valve cover bolts?
I also have 89 Full Size 5.7 TBI Chevy Blazer wires from MSD (brand new), was wondering if i could just use them?
they are 90 degree boots on them
the trucks used manifolds that went downward, the F-bodies used an upward manifold, so not sure if these would fit without rubbing/burning somewhere.
thoughts?
anyone used the MSD pre-wired kit?