im finally done with my conversion from 89 305 TBI to 89 350 TPI....i have done everything except the ECM and prom....i know i need a 165 ecm but i need a chip just to get my car moving decently..... i know this is a stupid question that has been answered a million times but it is always answered with "do a search" or "burn your own proms"...the problem is that there is too much info on DIY prom burning to get an easy answer out of it... i plan on doing my own prom stuff but for now i just want to get on the road....any suggestions? Thanks, Steve

 

If it is basically a stock car just by the factory prom. They are still available.

 

Well i have done the basics(headers, exhaust, mild cam, cold air intake, new accel distributor, and a rebuilt trans with a 2500 stall) which is i guess quite a few mods....do you think a stock chip would be ok until i get into DIY burning? Thanks for the reply

 

What do you mean by mild cam? waht are the specs?

later

rick

 

well thats one of the problems i face....i bought a used engine and i have the reciept from the rebuild and the part numbers arent on there....all it says is "comp performance roller cam"....the guy i bought it from said it was a "mild cam" Thats all the info i have on it...Thanks,
Steve