Fuel injectors
Fuel injectors
I'm looking to purchase a new set of injectors.I see Accel makes a set of 22lb injectors and Holly has a set of 24lb injectors.Have any of you guys tried these products?I like some opinions THanks
------------------
87GTA,350,Auto,MAF screens removed,K&N,modified air intake,ADSchip,3:73s,3inch cat back Flowmaster,TPS.54,Bosch Plat plugs,base timing 6BTDC,Bilstiens in the rear....,don't let yer meat loaf
[This message has been edited by RP1987GTA (edited October 04, 2000).]
------------------
87GTA,350,Auto,MAF screens removed,K&N,modified air intake,ADSchip,3:73s,3inch cat back Flowmaster,TPS.54,Bosch Plat plugs,base timing 6BTDC,Bilstiens in the rear....,don't let yer meat loaf
[This message has been edited by RP1987GTA (edited October 04, 2000).]
I run SVO 24# injectors and they are fine. Probably a little less expensive. First let me say you best have some serious mods for 24# injectors. The 22# will support around 400HP. If there a little old have RIch at Cruzin performance clean, flow and match them for around $15 each..... I got my 24# at TPI Tech flow matched for $260
------------------
Hank
87'IROC Z28
Hanks 87 IROC
------------------
Hank
87'IROC Z28
Hanks 87 IROC
thanks for the input..do you have a web address for TPItech flow?Also do you know any co. that make a good complete kit to go to Speed Density system?
------------------
87GTA,350,Auto,MAF screens removed,K&N,modified air intake,ADSchip,3:73s,3inch cat back Flowmaster,TPS.54,Bosch Plat plugs,base timing 6BTDC,Bilstiens in the rear....,don't let yer meat loaf
------------------
87GTA,350,Auto,MAF screens removed,K&N,modified air intake,ADSchip,3:73s,3inch cat back Flowmaster,TPS.54,Bosch Plat plugs,base timing 6BTDC,Bilstiens in the rear....,don't let yer meat loaf
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
6
Oct 4, 2015 11:27 PM
Firechicken86
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 12, 2015 10:07 PM




