Injector guru's help. What lb per hr are these
Thread Starter
Banned
iTrader: (3)
Joined: Dec 2007
Posts: 275
Likes: 0
Car: 2006 Ford Mustang
Engine: 4.0 V-6
Transmission: Automatic
Axle/Gears: not sure
Injector guru's help. What lb per hr are these
okay they have the same blue strip as this picture but .... these are numbered D1570BACan't find anyone who knows what they are besides delphi/lucas
Supreme Member
Joined: Jan 2003
Posts: 2,133
Likes: 4
From: Houston, Texas
Car: 88' IROCZ
Engine: 388 TPI Motown 350 Race block
Transmission: 700R4
Axle/Gears: 2.77
Re: Injector guru's help. What lb per hr are these
Part Number Delphi D1570BA (Lucas Old 5207002, Lucas New 621015)
Static Flow Rate @ 43.5PSI (300kPa)
19.86 lb/hr = 208.5cc/min = 150.3g/m
Static Flow Rate @ 43.5PSI (300kPa)
19.86 lb/hr = 208.5cc/min = 150.3g/m
Thread Starter
Banned
iTrader: (3)
Joined: Dec 2007
Posts: 275
Likes: 0
Car: 2006 Ford Mustang
Engine: 4.0 V-6
Transmission: Automatic
Axle/Gears: not sure
Re: Injector guru's help. What lb per hr are these
Thanks. I've heard they are 24's then 28's and one guy said 36's ..... so you are positive they are 19's
Junior Member
Joined: Dec 2007
Posts: 68
Likes: 0
Re: Injector guru's help. What lb per hr are these
ive looked these up also and found conflicting answers. I finally wrote down in my notes, '87-88 lucas/delphi 24 lbs. This guy swore by it.
I will get a better idea in a couple weeks when I get my programmer and start playing w/ injector constant to lower my BLMs, Ill see what size I end up at.
I will get a better idea in a couple weeks when I get my programmer and start playing w/ injector constant to lower my BLMs, Ill see what size I end up at.
Thread Starter
Banned
iTrader: (3)
Joined: Dec 2007
Posts: 275
Likes: 0
Car: 2006 Ford Mustang
Engine: 4.0 V-6
Transmission: Automatic
Axle/Gears: not sure
Re: Injector guru's help. What lb per hr are these
ive looked these up also and found conflicting answers. I finally wrote down in my notes, '87-88 lucas/delphi 24 lbs. This guy swore by it.
I will get a better idea in a couple weeks when I get my programmer and start playing w/ injector constant to lower my BLMs, Ill see what size I end up at.
I will get a better idea in a couple weeks when I get my programmer and start playing w/ injector constant to lower my BLMs, Ill see what size I end up at.
Thread
Thread Starter
Forum
Replies
Last Post
