I have a few questions about porting:

How difficult is it really? I have no experience doing these sorts of things at all
Who makes gaskets for ported TPI?
Whats the most effective part of the Tune Port to port?
Besides for the Dremel tool what else do you need to do your own porting?

Thanks,
-Timbo-

 

Look in the tech section of this site and look arround for the articles on porting. That will give you a good idea of what you will be getting yourself into.

 

when i did my porting, i was worried and didn't know wut to do, but once u get started its easy and it makes since what to cut once u get started.

------------------
- David
88' GTA 5.7L TPI MODS---> air foil, K&N, Shift Kit, 180* therm, TB bypass, Gutted CAT, Flowmaster 80 Series Muffler added to Unkown CatBack, Ported Intake

http://www.geocities.com/david_angel_16

 

It not that hard just take your time remember once its gone their is no putting it back.Most of use use the tpis big mouth manifold gaskets.

------------------
87gta 355 fastburn heads,slp headers,flowmaster exhaust, LT4 hot cam and a lot more

 

I am going to port my plenum and base, maybe siamese it all up a little bit in a a couple weeks. What gaskets would I need?