Is it possible to "easily" mod an LT1 intake for a SBC to replace TPI?
Thread Starter
Senior Member
Joined: Feb 2009
Posts: 874
Likes: 18
From: Brisbane, Australia
Car: 1985 Pontiac TransAM
Engine: 400SBC 24x conversion
Transmission: T700r Stage2 Shiftkitted
Axle/Gears: 2.77 9 Bolt
Is it possible to "easily" mod an LT1 intake for a SBC to replace TPI?
Hey Guys,
Also posted this in engine swap encase its more aligned to that part,
but is it possible to mod the LT1 intake to fit on a 86-95 SBC 350 currently with TPI?
I know there's something to do with an water inlet, but can it be blocked or ported through the intake, and if so how much would it cost to do?
Also posted this in engine swap encase its more aligned to that part,
but is it possible to mod the LT1 intake to fit on a 86-95 SBC 350 currently with TPI?
I know there's something to do with an water inlet, but can it be blocked or ported through the intake, and if so how much would it cost to do?
Supreme Member
iTrader: (1)
Joined: Aug 1999
Posts: 2,842
Likes: 6
From: Rowlett, TX
Car: 1988 GTA
Engine: 5.0 TPI
Transmission: T5
Axle/Gears: 9 Bolt, 3.45
Re: Is it possible to "easily" mod an LT1 intake for a SBC to replace TPI?
It takes some machine work on a few areas, but it's not too difficult. See here for details:
http://www.lt1intake.com/files/swapping.htm
http://www.lt1intake.com/files/swapping.htm
Thread
Thread Starter
Forum
Replies
Last Post
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM
