Porting intake 5.7 tpi
Thread Starter
Junior Member
Joined: Mar 2012
Posts: 36
Likes: 0
From: Quad Cities, IA
Car: 87 Camaro IROC-Z 5.7 TPI
Engine: 350 aka 5.7L Tuned Port Injection
Transmission: 700-R4
Axle/Gears: 3.27 posi
Porting intake 5.7 tpi
I am going to be Porting my intake 5.7 tpi stock. I have searched quite a bit but have not had a direct answer, so here goes.
Which gaskets should I buy? It looks like I need Mr. Gasket 146,for the runners and Plenum. Some have said felpro 1205 for the base but I also heard they do not fit 87 and up cast iron heads. Help pleeeassee. I wanna sherry this done in the next week.
Which gaskets should I buy? It looks like I need Mr. Gasket 146,for the runners and Plenum. Some have said felpro 1205 for the base but I also heard they do not fit 87 and up cast iron heads. Help pleeeassee. I wanna sherry this done in the next week.
Thread Starter
Junior Member
Joined: Mar 2012
Posts: 36
Likes: 0
From: Quad Cities, IA
Car: 87 Camaro IROC-Z 5.7 TPI
Engine: 350 aka 5.7L Tuned Port Injection
Transmission: 700-R4
Axle/Gears: 3.27 posi
Re: Porting intake 5.7 tpi
BTW I'm planning as much DIY porting as possible on a stock setup
Senior Member
Joined: Jun 2011
Posts: 839
Likes: 4
From: Melbourne, Australia
Car: 1988 IROC Camaro (RHD)
Engine: 350 ci L98 SBC
Transmission: T700
Axle/Gears: 9 bolt BW, Disk, Posi-traction
Senior Member
Joined: Jun 2011
Posts: 839
Likes: 4
From: Melbourne, Australia
Car: 1988 IROC Camaro (RHD)
Engine: 350 ci L98 SBC
Transmission: T700
Axle/Gears: 9 bolt BW, Disk, Posi-traction
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
Nov 14, 2015 12:02 AM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM
