TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

speed density L98 rev and start put wont idle

Thread Tools
 
Search this Thread
 
Old Mar 11, 2015 | 05:37 AM
  #1  
kad5118's Avatar
Thread Starter
Member
 
Joined: Mar 2010
Posts: 178
Likes: 1
Car: 91 gta ws6
Engine: L98
Transmission: 700 R4 TRANS
Axle/Gears: 3.23
speed density L98 rev and start put wont idle

horrible day for my gta.I went to advance auto and brought some high mileage Freon for the ac unit in my car i put a half of can of the Freon through the ac low side.to get the compressor to engage because it was locked.it as in the ac compressor started to engage off and on but it wasn't consistant so i shut the car off to go inside of advance auto to buy one more can of Freon.When i attempted to start the car it would turn on and idle for like 2 to 4 seconds then it would turn off on its on.Like it had just died or something now as long as i slightly press the gas the car will idle normal.when i take my foot off the gas it dies


these are the things that i inspected.

the injector fuses
vacuum lines
spark plugs wires
throttle body
throttle cable
checked va lines to sd sensor


here are some of the things that i corrected

installed a new coil
sprayed throttle body cleaner in the throttle body
reseat all spark plug wires
advanced the distributor a tiny tiny bit to increase idle pass 500 rpm

with all that i have done it still dies and i dont know why any ideas
Reply
Old Mar 11, 2015 | 07:33 AM
  #2  
kad5118's Avatar
Thread Starter
Member
 
Joined: Mar 2010
Posts: 178
Likes: 1
Car: 91 gta ws6
Engine: L98
Transmission: 700 R4 TRANS
Axle/Gears: 3.23
Re: speed density L98 rev and start put wont idle

Any experienced mechanics in here or some one who has had this problem before
Reply
Old Mar 11, 2015 | 10:58 AM
  #3  
kad5118's Avatar
Thread Starter
Member
 
Joined: Mar 2010
Posts: 178
Likes: 1
Car: 91 gta ws6
Engine: L98
Transmission: 700 R4 TRANS
Axle/Gears: 3.23
Re: speed density L98 rev and start put wont idle

bump
Reply
Old Mar 11, 2015 | 12:20 PM
  #4  
Bob88GTA's Avatar
Supreme Member
20 Year Member
iTrader: (2)
 
Joined: Apr 2000
Posts: 3,938
Likes: 99
From: Huntsville AL
Car: 88GTA
Engine: 5.7TPI
Transmission: Auto
Axle/Gears: 3.27
Re: speed density L98 rev and start put wont idle

Follow this to the T.
Should fix you up.

https://www.thirdgen.org/newdesign/tech/tpimod2.shtml
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Andrew6.688
TPI
10
Dec 13, 2015 10:59 AM
db057
Tech / General Engine
4
Aug 22, 2015 08:17 PM
mizz0313
Transmissions and Drivetrain
3
Aug 12, 2015 06:45 AM
86Base
TPI
14
Aug 8, 2015 01:34 PM




All times are GMT -5. The time now is 07:02 PM.