Would someone be so kind to show me a picture front facing of a 350 TPI engine showing the bolts that hold the accessories brackets to the engine block / cylinder heads?

I removed mine a while ago and forgot to take note where they were.

I have 5 bolts with the torque head which I am assuming all belong to the power steering (drivers) side. For the AC compressor side I have one long torque head bolt which should go through the bracket holding the AC compressor however for the rest all I have are studs with a nut half way through. Maybe something else is also held by these bolts?

 

Year?

 

1988 350 serpentine setup with alternator on drivers side and AC Compressor on passenger side

 

Thanks to eBay for the image...

8 short (torx) bolts:
3x drivers head
1x passenger head + 1 long torx bolt below A/C... I think this is the upper AIR pump mount.
2x lower into the block on each side... Although original parts has a male-torx stud + 9/16" nut.

 

Thanks. From the picture I can see that one in each head is a stud. I must have one torx head missing but I think I'll manage with this information.

Thanks again

 

Putting a stud/nut in the head works, too. For whatever reason, I put the studs in the lower location. I haven't had a 88+ to know where the factory put them. Either way, the stud provides alignment during installation.

 

Related question. Considering I have these serpentine brackets, and the fact that I have 3 braces (one should connect with AC side bracket, one to the PAS Pump and one to the alternator) can someone send me a picture of the place where these braces bolt to the exhaust manifold bolts?

I have Edelbrock headers and I forgot where the spacers were located. I actually lost the spacers so I have to cut some again.