i installed the engine for the third time and just as i got done setting the timeing i put in gear and nothing happened, i tried it again putting it in park then drive and nothing but the car does move only at 3000 to 4000 rpm in drive and reverse. Its a 350 tranny and a 3200 stall. I know its a stall but i drove it with the same setup before and it was not like that, it would move as soon as i put it into gear. i ripped out the tranny in 15 min cause i thought the converter slipped out but i cant get it to go in any further, but there is still a space where you can feel the input shaft on the trans about 1/4 inch long between trans and converter