Here is a good one
Thread Starter
Supreme Member
Joined: Feb 2002
Posts: 1,843
Likes: 0
From: miami, florida
Here is a good one
Alright, after swapping in my TPI, I noticed a problem. When my car is in park or neutral, my scanner reads "R-DL." When the car is in a gear, it reads "P-N" Following the flow chart on my alldata, it says its a ground to ck 450.
Problem? It IS ALREADY A GROUND! I checked it anyways, and nothing showed up. I even checked the other one, and its fine too.
I checked it with a test light to the computer's connector, and it generates a ground pulse like it is supposed to at the correct times. I change the computer, and it does the same thing.
Ideas?
Problem? It IS ALREADY A GROUND! I checked it anyways, and nothing showed up. I even checked the other one, and its fine too.
I checked it with a test light to the computer's connector, and it generates a ground pulse like it is supposed to at the correct times. I change the computer, and it does the same thing.
Ideas?
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM