Has anyone done this mod?
Thread Starter
Junior Member
iTrader: (1)
Joined: Oct 2006
Posts: 57
Likes: 0
From: Mountain View, CA
Car: 1991 Chevrolet Camaro Z28
Engine: 350
Transmission: Tremac T-56 6 Speed
Axle/Gears: 10 Bolt 3.73 POSI
Has anyone done this mod?
Has anyone drilled out the restrictor between the clutch master and slave cylinder as seen in this article
http://www.chevyhiperformance.com/howto/39021/
If so has anyone actually noticed a differance in shifts?
http://www.chevyhiperformance.com/howto/39021/
If so has anyone actually noticed a differance in shifts?
Re: Has anyone done this mod?
That's an interesting article. I'm using the braided line from a 93-97 on my setup. I'll have to check and see if it's got that restictor in it after reading that. 
Member
Joined: Feb 2001
Posts: 314
Likes: 0
From: Mesquite, Texas
Car: 1992 Chevrolet RS Camaro
Engine: 305 TBI
Transmission: WC T5 conversion
Axle/Gears: Debatable . . .
Re: Has anyone done this mod?
It shouldn't. I never had any problem like that in my 97 Z28. The 97 powershifted just fine into any gear it was told to.
*EDIT*
Of course pushing the clutch pedal in that car was like trying to shove a boulder off the cliff onto the Roadrunner.
*EDIT*
Of course pushing the clutch pedal in that car was like trying to shove a boulder off the cliff onto the Roadrunner.
Last edited by racer J; May 12, 2007 at 11:16 AM. Reason: Additional information . . .
Thread
Thread Starter
Forum
Replies
Last Post