quick question
Thread Starter
Member
iTrader: (1)
Joined: Jun 2007
Posts: 253
Likes: 0
From: Rhode Island
Car: 1989 GTA
Engine: 355 with Super Ram
Transmission: 700R4
Axle/Gears: 3.73 10 bolt with a True-trac
quick question
i read a lot about people putting aluminum drive shafts in their cars. the question is my gta has an aluminum drive shaft and it come that way. i know this because it was a one owner car and the guy was 95 when he died. the car has never been touched before i bought it. so should this car have a steel shaft or did gta's come with aluminum. just wondering and have no plans on changing it.
Joined: Aug 2006
Posts: 12,805
Likes: 107
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: quick question
i read a lot about people putting aluminum drive shafts in their cars. the question is my gta has an aluminum drive shaft and it come that way. i know this because it was a one owner car and the guy was 95 when he died. the car has never been touched before i bought it. so should this car have a steel shaft or did gta's come with aluminum. just wondering and have no plans on changing it.
Thread Starter
Member
iTrader: (1)
Joined: Jun 2007
Posts: 253
Likes: 0
From: Rhode Island
Car: 1989 GTA
Engine: 355 with Super Ram
Transmission: 700R4
Axle/Gears: 3.73 10 bolt with a True-trac
Re: quick question
i was wondering about that. my old Iroc had a steel drive shaft and i did see a TSB on vibration but didn't read it.
Thread Starter
Member
iTrader: (1)
Joined: Jun 2007
Posts: 253
Likes: 0
From: Rhode Island
Car: 1989 GTA
Engine: 355 with Super Ram
Transmission: 700R4
Axle/Gears: 3.73 10 bolt with a True-trac
Re: quick question
yep yep i have that RPO code 
thanks for the info i knew someone here would know the answer.
thanks for the info i knew someone here would know the answer.
Thread
Thread Starter
Forum
Replies
Last Post