Torque converter compatability question...
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 1,053
Likes: 3
From: San Diego, CA
Car: 87 Buick GN
Engine: 3.8L (231 cid) V6
Transmission: 200-4R
Axle/Gears: 10 bolt G80/ 3.42
Torque converter compatability question...
Will a torque converter for a 4L60-E work on a 700R4? Thanks...
------------------
1989 IROC-Z, ZZ3 shortblock with some bolt-ons.
13.20 @ 108.69, 2.2 60'
------------------
1989 IROC-Z, ZZ3 shortblock with some bolt-ons.
13.20 @ 108.69, 2.2 60'
Member
Joined: Feb 2001
Posts: 314
Likes: 0
From: Mesquite, Texas
Car: 1992 Chevrolet RS Camaro
Engine: 305 TBI
Transmission: WC T5 conversion
Axle/Gears: Debatable . . .
I'm not an expert on this so I could be wrong. However I don't know why it wouldn't. They both have tcc controllers in the transmissions and they sould have the same splines on the inout shafts.
------------------
1988 Camaro
305 bored .030 over
Stock TBI
Aluminum radiator
No smog pump
gutted factor cleaner
cam ground to crane specs
timing advanced 9 degrees
no thermostat
other than that its bone stock and ran a 16.4 @ 82 mph with earth shattering wheel hop and a 2.88 60 ft time. (this was with the rebuild and cam only)
------------------
1988 Camaro
305 bored .030 over
Stock TBI
Aluminum radiator
No smog pump
gutted factor cleaner
cam ground to crane specs
timing advanced 9 degrees
no thermostat
other than that its bone stock and ran a 16.4 @ 82 mph with earth shattering wheel hop and a 2.88 60 ft time. (this was with the rebuild and cam only)
Senior Member
iTrader: (1)
Joined: Dec 2003
Posts: 703
Likes: 0
From: Ravenna, Ohio
Car: 87 Trans Am GTA
Engine: 408 LS
Transmission: LS 4L60E
Axle/Gears: 9 Bolt/3.70 Gears/TAP Girdle
can anybody answer this question better? I have a buddy looking to get rid of his converter for his lt1 car and i'm in need of one for my 700r4. Will the lt1 converter work or are the shafts different?
Thread
Thread Starter
Forum
Replies
Last Post
Ragtop Man
Transmissions and Drivetrain
2
Sep 12, 2015 12:23 AM