OK I need to some help here!
Thread Starter
Supreme Member
Joined: Nov 2006
Posts: 1,724
Likes: 1
From: NY sucks
Car: 84' Corvette, 96' Caprice
Engine: LT1, L99
Transmission: T-56, 4L60e
Axle/Gears: 3.07 POSI, 2.93 Open
OK I need to some help here!
I am installing a shift kit, and i broke the servo cover, the one in the side of the tranny on the pass. side.... push in and remove a metal clip/ring thing. Well mine decided to weld intself onto the case and would not move.... so i hit it with a hammer and it shattered. i did get it out in the wrong manner, anyone on this site have a junk 700r4 with that cover? I'll pay for it, i just need one really bad. All i can find is a kit with the cover and servo, i don't need the servo i just need the cover. Thanks a lot!
Thread Starter
Supreme Member
Joined: Nov 2006
Posts: 1,724
Likes: 1
From: NY sucks
Car: 84' Corvette, 96' Caprice
Engine: LT1, L99
Transmission: T-56, 4L60e
Axle/Gears: 3.07 POSI, 2.93 Open
Re: OK I need to some help here!
Ok another question, i just went ahead and bought a billet servo cover and 4th gear servo as a combo from Jet.(the only way i could get the cover.) Should i use the Transgo servo or should i use the Jet 4th gear servo that i got with the cover?