hydraulic linkage master/slave from a t5.....
Thread Starter
Joined: May 2006
Posts: 206
Likes: 2
From: Center Line, Michigan
Car: 88 Iroc
Engine: 383
Transmission: T56
Axle/Gears: 3.43
hydraulic linkage master/slave from a t5.....
hydraulic linkage master/slave from a t5 will they would with a t56?????
Joined: Aug 2006
Posts: 12,805
Likes: 107
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: hydraulic linkage master/slave from a t5.....
not positive.
the trans needs to be a 93-97 t56, the later ones used hydraulic TO bearings. The master slave setup from the t56 cars has a longer flex line, because the slaves mounts in a different direction from the 3rd gens position. Im not sure if the stock 3rd gen line is long enough.
the trans needs to be a 93-97 t56, the later ones used hydraulic TO bearings. The master slave setup from the t56 cars has a longer flex line, because the slaves mounts in a different direction from the 3rd gens position. Im not sure if the stock 3rd gen line is long enough.
Thread
Thread Starter
Forum
Replies
Last Post
88SS6SPEED
Engine/Drivetrain/Suspension Parts for Sale
7
Nov 11, 2015 07:05 AM
IROCNParts
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 24, 2015 10:50 AM
