I like it This is a scrap piece of aluminum. Our heat-treating oven came in handy. It will hold 15"h, 20"w, and 17" deep, and figured we could put it to more use.

 

Messed around with some valve covers. They would have looked better if I sanded the casting lumps off, but wanted to see how they would look...

 

nice. i like powder coating, its so thick almost everything looks good hehe, id like a set of black rocker covers :-)

 

Sure. I have a set I can do, just send yours back when you get them. Pay shipping and $20 to help buy the powder

Gloss black? The ones in the pic are matte black.

 

Would you be interested in coating a 3x00 top end?

 

Sure. I don't have any UIM's here, but I have LIM's and plenty of valve covers (I guess it doesnt matter still paying 2x shipping). Heads too? I'd probably have to charge a little more for those parts, that's lots of media blasting!

 

I was thinking the UIM, LIM, and the valve covers. I'm not to worried about the heads. I have the numbers and EGR stuff ground off my UIM...its also lightly painted. The valve covers are already cleaned, and the LIM is still dirty. Ill probably do this a little closer to the finish date, as money is tight for me right now.
but sounds like you're expanding nicely.

 

Want to do a superram by any chance?

 

As long as it fits 13" high, 20" wide, and 17" deep it will fit in our heat-treating oven (100-700*). When I get a chance, I want to look at some used commercial kitchen ovens and see if we can go bigger.