Who makes a cold air intake for a 2.8.
K&N doesn't make one.

Good luck trying to find one I have looked every where, and cant find one, you will have to do what the rest of us did MAKE YOUR OWN!:hail:

I gave up and made my own. What I did was used heat resistant flexible vent tubbing, and cut it to the right length, and like a dumb ***, I tryed to reuse the maf by drilling a hole the side to screw in the sensor that was on the old intake and screwed it into the maf, and my friend and I used epoxy to attach a cone K&N air filter to the end of it. It works pretty well, expcept I'm pretty sure I busted the maf becuase when I hook it up, the engine dies right after I start it. So it's just unconnected right now.

E-mail 89camarorsV6 , he has one I think , or atleast knows how to make one .

If I'm right in guessing, the 2.8 air intake is setup the same as my 3.1 stock intake. In that case I purchased a CAI from SLP for my car. If it works on my 3.1 I would have to imagine it would work on your 2.8 as well! If you're interested in this lemmie know and I'll find it on their site for you. Below is the address to the main site.

http://www.slponline.com


Mark

I'll make one for your, as long as you pay me