Looking for a shop to refinish IROC wheels.
Thread Starter
Member
iTrader: (3)
Joined: Jul 2018
Posts: 288
Likes: 68
From: Ohio
Car: 1989 IROC
Engine: 5.7 TPI
Axle/Gears: 2.77 Posi
Looking for a shop to refinish IROC wheels.
Anyone have a recommendation in the NE Ohio or NW Pennsylvania area? Hoping to avoid shipping the wheels, but I want someone who will do this right. Back to factory condition or even a hair glossing.
I do not trust myself to do a presentable job, so sending them out will be the approach.
I do not trust myself to do a presentable job, so sending them out will be the approach.
Member
Joined: Apr 2023
Posts: 121
Likes: 17
From: Earth
Car: One Chevy built in the 80s
Engine: 5.7 crate
Transmission: 700R4
Axle/Gears: Quick performance 9” 3.70
Re: Looking for a shop to refinish IROC wheels.
Anyone have a recommendation in the NE Ohio or NW Pennsylvania area? Hoping to avoid shipping the wheels, but I want someone who will do this right. Back to factory condition or even a hair glossing.
I do not trust myself to do a presentable job, so sending them out will be the approach.
I do not trust myself to do a presentable job, so sending them out will be the approach.
Member
Joined: Oct 2018
Posts: 287
Likes: 224
From: Ft Wayne, IN
Car: Irocs 87 Conv 5 spd & 87 T-Top auto
Engine: LB9/L98
Transmission: MM5/Auto
Re: Looking for a shop to refinish IROC wheels.
It is about 3.5 hour drive, but there is a place in Warren, IN that does them. The gas for the two round trips would be cheaper than shipping them. I had a set done a couple years ago, I believe it was around $650ish. The contact I had at the time was Shelly Olson (813) 313-5038 or e-mail solson@lkqcorp.com
Last edited by IROCIN; Jun 20, 2023 at 06:20 PM.
Thread
Thread Starter
Forum
Replies
Last Post