My Post Pictures

March 29, 2020

19

0

outer edges are pretty close

outer edges are pretty close

0 2020/03/29 10:53:37 ternandes

inside of outer supports has a big gap

inside of outer supports has a big gap

0 2020/03/29 10:53:39 ternandes

gap on other side

gap on other side

0 2020/03/29 10:53:55 ternandes

should I taper these to more of a point?

should I taper these to more of a point?

0 2020/03/29 10:54:04 ternandes

After lots of measuring, adjusting, and fidgeting, I marked the deck lid with a Sharpie to locate the spoiler during trial and error fitment.

After lots of measuring, adjusting, and fidgeting, I marked the deck lid with a Sharpie to locate the spoiler during trial and error fitment.

0 2020/04/04 11:37:06 ternandes

Then I ground the outer edges of the outer mounts to get them closer to the contour of the deck lid. I stopped when I got it flush with the stud mounting hole.

Then I ground the outer edges of the outer mounts to get them closer to the contour of the deck lid. I stopped when I got it flush with the stud mounting hole.

0 2020/04/04 11:40:05 ternandes

The new mounting hole is JUST far enough away from the glass.

The new mounting hole is JUST far enough away from the glass.

0 2020/04/04 11:42:47 ternandes

The pigtail for the third brake light is not in a good spot.

The pigtail for the third brake light is not in a good spot.

0 2020/04/04 11:44:08 ternandes

I pulled the pigtail through the new hole. It will now plug right in when the spoiler is installed.

I pulled the pigtail through the new hole. It will now plug right in when the spoiler is installed.

0 2020/04/04 11:45:13 ternandes

I enlarged an existing hole in the left inner mount.

I enlarged an existing hole in the left inner mount.

0 2020/04/04 11:46:15 ternandes

0 2020/04/18 09:32:29 ternandes

0 2020/04/18 09:34:27 ternandes

0 2020/04/18 09:39:39 ternandes

0 2020/04/18 09:41:05 ternandes

0 2020/04/18 09:41:31 ternandes

0 2020/04/18 09:41:40 ternandes

I glued the extensions to the spoiler with Gorilla Glue, and used PK screws and washers to temporarily clamp it. Those same screws will mount it to the deck during final assembly

I glued the extensions to the spoiler with Gorilla Glue, and used PK screws and washers to temporarily clamp it. Those same screws will mount it to the deck during final assembly

0 2020/05/30 12:09:12 ternandes

0 2020/05/30 12:09:31 ternandes

0 2020/05/31 12:25:54 ternandes