Third Generation F-Body Message Boards
Dry run number 3 on the gauges
Dry run number 3 on the gauges
0 2012/04/05 07:50:06
Camaro March 2011, just before strip down
Camaro March 2011, just before strip down
0 2012/04/05 07:50:06
Not best spray job I am sure but my first car, man its a lot easier doing bikes
Not best spray job I am sure but my first car, man its a lot easier doing bikes
0 2012/04/06 20:16:02
Sealer on now for good few days at prep
Sealer on now for good few days at prep
0 2012/04/06 20:16:02
Two days to get engine out
Two days to get engine out
0 2012/04/06 20:16:02
Lucky to find local small company that did a good job on interior. Purists may be annoyed at my choice of Z-28 graphics but not after original restoration but what I think works.
Lucky to find local small company that did a good job on interior. Purists may be annoyed at my choice of Z-28 graphics but not after original restoration but what I think works.
0 2012/04/06 20:20:22
Rear seats done
Rear seats done
0 2012/04/06 20:20:22
Door panel without the arm rests which are the same grey with red stitching.
Door panel without the arm rests which are the same grey with red stitching.
0 2012/04/06 20:20:22
Front bumper just arrived, $460 to buy in US and $1800 to ship to Australia!!!!!!
Front bumper just arrived, $460 to buy in US and $1800 to ship to Australia!!!!!!
0 2012/04/06 20:27:30
Its going to take a lot of work to clean this up for new V8.
Its going to take a lot of work to clean this up for new V8.
0 2012/04/06 20:27:30
Engine bay nearly there, new steering will have to be done after engine is in.
Engine bay nearly there, new steering will have to be done after engine is in.
0 2012/04/06 20:27:30
Not 100% happy with warning lights found some in UK Lotus use in brushed aluminium that will look better. Gauges work though (Tach, Speedo, Fuel, Oil Pressure, Water Temp, Voltage) just ordered vacuum and oil temp for centre consul.
Not 100% happy with warning lights found some in UK Lotus use in brushed aluminium that will look better. Gauges work though (Tach, Speedo, Fuel, Oil Pressure, Water Temp, Voltage) just ordered vacuum and oil temp for centre consul.
0 2012/04/06 20:33:05
Back pretty simple just amp to add and good clean when done.
Back pretty simple just amp to add and good clean when done.
0 2012/04/06 20:33:05
Mega Shifter to add, and two Drift gauges in centre consul as well as ignition start button where ash tray goes.........
Mega Shifter to add, and two Drift gauges in centre consul as well as ignition start button where ash tray goes.........
0 2012/04/06 20:33:05