Third Generation F-Body Message Boards
0 2015/07/31 15:29:19
0 2016/04/25 22:34:59
That lever must be there or the pull-down unit will not release the hatch hook when it reaches the end of the up cycle
That lever must be there or the pull-down unit will not release the hatch hook when it reaches the end of the up cycle
0 2016/04/25 22:45:46
91.5-92 latch assembly
91.5-92 latch assembly
0 2016/08/10 08:46:55
0 2016/10/13 23:25:49
0 2016/10/13 23:31:40
This is the correct hole to use for mounting the end of the cable. The outer hole was used for the earlier release that used rods and links. Lon Salgren Top-Down Solutions
This is the correct hole to use for mounting the end of the cable. The outer hole was used for the earlier release that used rods and links. Lon Salgren Top-Down Solutions
0 2017/02/08 23:45:19
0 2017/02/09 08:25:15
0 2018/09/28 23:08:13
0 2019/04/12 09:43:30
0 2019/05/01 10:20:31
Test the reversing switch using a multimeter for continuity as shown in the attached picture. With the switch set as if it has completed the "up" cycle test between R and orange, then test between L and blue. Next flip the switch as if it has completed the down cycle. Test between the R and blue, then L and white. If you have an open in any of the tests you've found that problem. GM discontinued it long ago, but I sell it inder my part number 205180 on the web site www.top-downsolutions.com.
Test the reversing switch using a multimeter for continuity as shown in the attached picture. With the switch set as if it has completed the "up" cycle test between R and orange, then test between L and blue. Next flip the switch as if it has completed the down cycle. Test between the R and blue, then L and white. If you have an open in any of the tests you've found that problem. GM discontinued it long ago, but I sell it inder my part number 205180 on the web site www.top-downsolutions.com.
0 2019/06/30 19:23:54
The latch release lever is circled in red.
The latch release lever is circled in red.
0 2020/09/10 21:22:57
Latch release lever is circled.
Latch release lever is circled.
0 2020/09/10 21:25:40
0 2021/05/14 08:11:07
1LE end link
1LE end link
0 2021/07/11 07:59:30
0 2022/08/25 18:30:30
Your ground wire is present. You just need to move it from under the 13mm bolt to the 10mm screw that mounts the solenoid to the latch assembly as shown.
Your ground wire is present. You just need to move it from under the 13mm bolt to the 10mm screw that mounts the solenoid to the latch assembly as shown.
0 2022/08/25 18:32:55