Third Generation F-Body Message Boards
Heater hoses shortened a bit for a better look.
Heater hoses shortened a bit for a better look.
0 2018/08/14 15:28:18
0 2018/08/07 10:42:34
0 2018/08/07 10:42:31
0 2018/08/07 10:42:30
Mount bushing now put in correct orientation. Note the longer side pointing to the right (by the bolt)
Mount bushing now put in correct orientation. Note the longer side pointing to the right (by the bolt)
0 2018/08/07 10:34:35
About a half inch misaligned.
About a half inch misaligned.
0 2018/08/07 10:34:33
0 2018/08/07 10:33:16
No cigar
No cigar
0 2018/08/07 09:30:30
Close, but looks horrible in person.
Close, but looks horrible in person.
0 2018/08/07 09:30:28
0 2018/08/07 09:27:44
0 2018/08/07 09:27:43
Mock Up
Mock Up
0 2018/08/07 09:24:27
Looks "ok" from this picture and this is what you see on the boards a lot that make you think it is easier said than done. It's not, and this looked like crap in person.
Looks "ok" from this picture and this is what you see on the boards a lot that make you think it is easier said than done. It's not, and this looked like crap in person.
0 2018/08/07 09:24:26
Close, but not enough
Close, but not enough
0 2018/08/07 09:24:25
Other side of tire is hitting the panhard rod mount and this side sticks out (looking down)
Other side of tire is hitting the panhard rod mount and this side sticks out (looking down)
0 2018/08/07 09:24:23
Tire looks close but would hit fender well
Tire looks close but would hit fender well
0 2018/08/07 09:24:22
Tire hits panhard rod mount
Tire hits panhard rod mount
0 2018/08/07 09:24:17
Mock Up of 335.
Mock Up of 335.
0 2018/08/07 09:21:04
Close, but no room for suspension travel
Close, but no room for suspension travel
0 2018/08/07 09:21:02
Looked way worse in person
Looked way worse in person
0 2018/08/07 09:21:01
Top down view showing the tire stick out
Top down view showing the tire stick out
0 2018/08/07 09:20:59
Looks "close" and this is the view you often see on the internet. In person it looks horrible.
Looks "close" and this is the view you often see on the internet. In person it looks horrible.
0 2018/08/07 09:20:58
Tire hits panhard mount and still sticks outside of fender.
Tire hits panhard mount and still sticks outside of fender.
0 2018/08/07 09:20:53
Driver Side Tub (about a half inch from shock mount wall).
Driver Side Tub (about a half inch from shock mount wall).
0 2018/08/07 09:20:10
Passenger side tun going all the way to shock mount.
Passenger side tun going all the way to shock mount.
0 2018/08/07 09:20:08
0 2018/07/22 07:13:35
0 2018/07/22 07:13:24
0 2018/07/20 11:49:43
0 2018/07/20 11:49:12
0 2018/07/20 11:46:44
Not really digging the yellow Konis against the red.
Not really digging the yellow Konis against the red.
0 2018/07/20 11:46:33
That's a custom trans cross member.
That's a custom trans cross member.
0 2018/07/20 11:46:20
0 2018/07/20 11:46:03
0 2018/07/20 11:45:37
0 2018/07/18 06:29:05
0 2018/07/18 06:28:52
0 2018/07/18 06:28:49
I adjusted my floor jack a bit to level the engine a bit better. This helped with the oil pan clearance as well as the firewall clearance. I should be able to remove the jack and get the trans cross member in this week.
I adjusted my floor jack a bit to level the engine a bit better. This helped with the oil pan clearance as well as the firewall clearance. I should be able to remove the jack and get the trans cross member in this week.
0 2018/07/16 12:49:32
Should have plenty of room to run the harness in my fabbed inlet.
Should have plenty of room to run the harness in my fabbed inlet.
0 2018/07/16 12:49:30
I had to set the intake on loosely. The rear mounted MAP was hitting the firewall. Once the trans is bolted in and the engine is no longer listing, I should have room for it.
I had to set the intake on loosely. The rear mounted MAP was hitting the firewall. Once the trans is bolted in and the engine is no longer listing, I should have room for it.
0 2018/07/16 12:49:28