[MI] Edelbrock RPM tailpipes, polished stainless
05-20-2009, 11:33 AM
#1
Senior Member
Thread Starter
iTrader: (8)
Join Date: Jul 2006
Location: Davisburg, MI
Posts: 683
Likes: 0
Received 1 Like
on
1 Post
Car: 87 Evoluzione, 84 TransAm, 05 GTO
Engine: LT1, L98, LS2
Transmission: (2) T56 & (1) 700R4
Axle/Gears: Moser 12-bolt w/3.73 & Stock
Edelbrock RPM tailpipes, polished stainless
I have the polished stainless tailpipes and 16ga aluminized steel elbows (4 pieces) from an Edelbrock RPM cat back system (EDL-5672). The elbows are swaged down to 2.5" I.D. inlet at the muffler and promptly flare out to 3" the rest of the way. $65 shipped to 48 states.
They just don't work on my Evoluzione so I bought new pieces to hack-up to fit car rather than trash these.
They just don't work on my Evoluzione so I bought new pieces to hack-up to fit car rather than trash these.
05-20-2009, 08:17 PM
#3
Senior Member
Thread Starter
iTrader: (8)
Join Date: Jul 2006
Location: Davisburg, MI
Posts: 683
Likes: 0
Received 1 Like
on
1 Post
Car: 87 Evoluzione, 84 TransAm, 05 GTO
Engine: LT1, L98, LS2
Transmission: (2) T56 & (1) 700R4
Axle/Gears: Moser 12-bolt w/3.73 & Stock
Re: Edelbrock RPM tailpipes, polished stainless
Pictures. Exhaust system was bought a couple years ago. One elbow was test fitted but engine wasn't started. Tips have not been unwrapped.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM
MikkoV
TPI
2
09-09-2015 04:25 PM
