[TX] Edelbrock Hi Flo Intake setup, Base, Runners, Plenum
Edelbrock Hi Flo Intake setup, Base, Runners, Plenum
Thought about this for a while and finally decided I needed to sell this instead of hoarding it. Prices do not include shipping.
Base is a 3860 Edelbrock ported by Darin Dochterman of High Flow Fuel injection. In good shape and not run since ported. For use with a 1205 gasket. Could use a repaint. $SOLD.
Runners are Edelbrock Hi Flo also ported and siamesed by Darin as well. Also not run since ported. $SOLD.
Ported and Siamesed Plenum. Darin did not do this one. $SOLD.
I will sell this whole setup together or separate. The base and runners alone are over $900 and there was $400 in extra portwork by Darin. He does very good work.
Thanks guys.
Base is a 3860 Edelbrock ported by Darin Dochterman of High Flow Fuel injection. In good shape and not run since ported. For use with a 1205 gasket. Could use a repaint. $SOLD.
Runners are Edelbrock Hi Flo also ported and siamesed by Darin as well. Also not run since ported. $SOLD.
Ported and Siamesed Plenum. Darin did not do this one. $SOLD.
I will sell this whole setup together or separate. The base and runners alone are over $900 and there was $400 in extra portwork by Darin. He does very good work.
Thanks guys.
Last edited by LT1Formula; Aug 27, 2014 at 02:10 AM.
Joined: Nov 2008
Posts: 2,090
Likes: 175
From: Milwaukee
Car: 92 Firebird, 77 Trans Am SE, 86 Z28
Engine: 5.7 HSR, T/A 6.6, empty
Transmission: T-5, TH350, T-5
Axle/Gears: 3.08 posi, 3.23 posi, 3.23
Re: Edelbrock Hi Flo Intake setup, Base, Runners, Plenum
PM sent
Thread
Thread Starter
Forum
Replies
Last Post