Louvers Again???
06-12-2006, 12:01 PM
#1
Junior Member
Thread Starter
Join Date: Jul 2005
Location: Lincolnton, NC
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 RS
Engine: 305 TBI
Transmission: Auto
Louvers Again???
I originally did this post about 6 months ago. I am searching for a set of louvers for a 89 camaro. I had many replies, and many good intentions. I settled on a set site unseen. Well they were the 3 piece set , and not what I wanted. I am looking for the 1 piece set, just like came on some of the 3rd generations. So anyone who can help please feel free to.
06-12-2006, 05:50 PM
#3
Junior Member
iTrader: (1)
Join Date: Mar 2004
Location: Edmonton, Alberta
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Iroc-z
Engine: LS1
Transmission: T56
Mine are aluminum in the middle and plastic on the sides and I don't think they come apart to make 3 pieces... got them from a wreckers. Maybe this picture will help.
06-12-2006, 05:55 PM
#4
Supreme Member
Join Date: Jul 2005
Location: North Central Mass.
Posts: 2,123
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Berlinetta
Engine: Megasquirted TPI
Transmission: Transgo 700R4
Axle/Gears: 3.42
Mine was a 1 piece.... Too bad they got run over... RIP louvers.
06-12-2006, 06:01 PM
#5
Supreme Member
iTrader: (1)
Join Date: Jul 2004
Location: Calgary, AB, Canada
Posts: 10,763
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
I've got a set in my basement, again, not 1 piece... center pieces are metal, sides are plastic. Like 10 pieces total.
I've never heard of a true 1 piece... How would they manufacture them...?
I've never heard of a true 1 piece... How would they manufacture them...?
06-12-2006, 06:06 PM
#6
Originally Posted by Sonix
I've got a set in my basement, again, not 1 piece... center pieces are metal, sides are plastic. Like 10 pieces total.
I've never heard of a true 1 piece... How would they manufacture them...?
I've never heard of a true 1 piece... How would they manufacture them...?
they do come apart its just not easy.
06-12-2006, 10:49 PM
#7
Junior Member
Thread Starter
Join Date: Jul 2005
Location: Lincolnton, NC
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 RS
Engine: 305 TBI
Transmission: Auto
But anyhow, Yes those are the ones I am looking for, with the straight slats. Does anyone want to sell a set with the mounting hardware, or can you tell me where to get them???
Thread
Thread Starter
Forum
Replies
Last Post
Christos
Auto Detailing and Appearance
7
09-10-2001 06:44 AM
Bulldog92
Auto Detailing and Appearance
6
07-17-2001 10:22 AM