Newbee question
07-21-2007, 08:48 AM
#1
Junior Member
Thread Starter
Join Date: Feb 2006
Location: kentucky
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 rs
Engine: 3.1 v6
Transmission: 700r4
Newbee question
Question 1 : which should i use to clean my gun after spraying urethane ?
Acetone or Laquer thinner??
Question 2 : Are the little baggie things that go inside the siphon cup for easy clean-up a good idea or not...
I am a first time painter getting ready to experiment with a urethane i got off the internet from the Kustom Shop called Hot Rod Flatz. It is pre-flattened and ready to shoot. I thought since my son likes the old school flat black rod look, this would hold up better than black primer...Oh well we will see
Thanks for any help !!
Acetone or Laquer thinner??
Question 2 : Are the little baggie things that go inside the siphon cup for easy clean-up a good idea or not...
I am a first time painter getting ready to experiment with a urethane i got off the internet from the Kustom Shop called Hot Rod Flatz. It is pre-flattened and ready to shoot. I thought since my son likes the old school flat black rod look, this would hold up better than black primer...Oh well we will see
Thanks for any help !!
07-21-2007, 07:04 PM
#4
Supreme Member
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Re: Newbee question
Laquer thinner, depending on the quality of the gun, I take it all apart and clean it. But if it's just a under 100$ gun, clean the bowl, tip, run laquer thinner through it with the tip on, and off, and leave the tip in the bowl with laquer thinner.
Thread
Thread Starter
Forum
Replies
Last Post