Z28 High Rise Spoiler
08-26-2009, 05:31 PM
#1
Z28 High Rise Spoiler
I've had this Z28 high rise for a while now, pulled from another car I owned. I didn't drill holes and mount this spoiler on my car, but instead I just swapped out the deck lids on each car. Both were 92 Camaros. Anyways, what I am trying to figure out is how to align this new deck lid on my car. It sticks out about a center meter from the body, and does not line up horizontally, or vertically, almost like it has an overbite. How can I fix this?
08-26-2009, 06:00 PM
#2
Senior Member
iTrader: (1)
Join Date: Apr 2004
Location: Prescott Valley AZ
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Iroc Showcar - Saturday Nite Hun
Engine: 383 4-Bolt Truck Hyd Roller MiniRam
Transmission: B&M 700R4 - Edge 3200
Axle/Gears: BW 9 Bolt-TA Cover & Stud Kit - 3.2
Re: Z28 High Rise Spoiler
I've had this Z28 high rise for a while now, pulled from another car I owned. I didn't drill holes and mount this spoiler on my car, but instead I just swapped out the deck lids on each car. Both were 92 Camaros. Anyways, what I am trying to figure out is how to align this new deck lid on my car. It sticks out about a center meter from the body, and does not line up horizontally, or vertically, almost like it has an overbite. How can I fix this?
know by changing a couple of them.
Body shop should be able to give you some tips for cheap.
Tweak damage maybe
Good luck
Later
Thread
Thread Starter
Forum
Replies
Last Post
