Need pics 1982 Trans Am crossfire injection cowl hood setup
#1
Need pics 1982 Trans Am crossfire injection cowl hood setup
I am putting the TA back together after months of having her apart and I forgot how the wiring is supposed to go back on the cowl induction set up. Specifically - I forgot where the ground wire goes, and also the retaining clip on the harness. It doesn't seem to line up with any holes that are within reach. The ones that are there are too big, unless I have the wrong screw for it. There are also 2 retaining clips I can't figure out. There is one on the body side of the harness, and also one on the hood side of the harness. So - if anyone has a pic it would be much appreciated.
Not sure if the carb setup has the ground and retaining clips in the same place, but if someone has that, feel free to post it here.
Not sure if the carb setup has the ground and retaining clips in the same place, but if someone has that, feel free to post it here.
#3
Senior Member
Join Date: Sep 2008
Location: France
Posts: 588
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1984 Pontiac Firebird Trans Am
Engine: V8 5.0L HO (L69)
Transmission: B&W T5
Axle/Gears: 3.73 limited slip
Re: Need pics 1982 Trans Am crossfire injection cowl hood setup
That's not for a CFI ut it's pretty much the same thing apart from the shape of the hole for the air cleaner :
But the harness is mostly hidden, I'll see if I find another picture.
But the harness is mostly hidden, I'll see if I find another picture.
#4
Re: Need pics 1982 Trans Am crossfire injection cowl hood setup
Thanks for the pic. I needed to know where the ground wire went. I think I have it figured out. When I put the cowl seal back on, it all kind of made sense because now I could see the unused holes.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
ElPaleterro85
Body
2
08-13-2015 03:49 PM
3rdgenparts
Firebirds for Sale
0
08-06-2015 09:03 AM