Weber/Dellorto
#3
Member
Join Date: Dec 1999
Location: waterford, CT 06385
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Are the jetting tables the same as for a Weber? If so, 'HP books' makes a nice Weber book which covers the side-draft and down-draft applications. You might try searching Amazon.com
#4
Junior Member
Thread Starter
Join Date: Oct 2001
Location: Sweden
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Nope.
It´s not the same as for Webers.
The 48DRLA;s ain´t really used OEM for anything as far as i know.
The VW crowd uses them alot however.
Nope.
No pics as of yet,but i´ll make sure to take some Damon.You know i will
I´ll try and get Pat over at the 2;nd gen board to post ém.
Putting the engine back in the car tomorrow,and ran into this intake setup by pure chance.
Stuff is all new and complete-sans some minor linkage pts.
Could say it ended up being a real steal as i was set back a set of used Crane SBC roller lifters and 400 bux..
It´s not the same as for Webers.
The 48DRLA;s ain´t really used OEM for anything as far as i know.
The VW crowd uses them alot however.
Nope.
No pics as of yet,but i´ll make sure to take some Damon.You know i will
I´ll try and get Pat over at the 2;nd gen board to post ém.
Putting the engine back in the car tomorrow,and ran into this intake setup by pure chance.
Stuff is all new and complete-sans some minor linkage pts.
Could say it ended up being a real steal as i was set back a set of used Crane SBC roller lifters and 400 bux..