FAST XFI start up file
#1
Supreme Member
Thread Starter
Join Date: Nov 2004
Location: Connecticut
Posts: 1,344
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
FAST XFI start up file
i was wondering if anyone has a setup close to mine that i can use there file to start up the car. see attached file for my spec's thanks
#2
Senior Member
Join Date: Jul 1999
Location: Haslett, MI
Posts: 900
Likes: 0
Received 1 Like
on
1 Post
Car: 1984 Trans Am WS6
Engine: Minirammed 385, 396 RWHP
Transmission: T56
Axle/Gears: 3.73 Moser 12-bolt
Re: FAST XFI start up file
Yeah, I have one that'll work for you.
It's on my laptop, so it'll have to wait until Monday. However I think you'll find that it's pretty darned close to what you want.
It's on my laptop, so it'll have to wait until Monday. However I think you'll find that it's pretty darned close to what you want.
#3
Supreme Member
Thread Starter
Join Date: Nov 2004
Location: Connecticut
Posts: 1,344
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
Re: FAST XFI start up file
thanks ws6transam i sent you a pm with my email. also a couple of quick questions. i am going to be running it in sequential instead of bank to bank so i swapped out my dist. so i can run it in sequential. the harness i got was the 30-1005 which is a bare harness that you cut to lenght. on the diagram it says hall effect on where the dist plugs in. do i need to hook up these wires causethe dist. from fast only has three wires out of it. i was wondering where the other wires go if i need to hook them up.
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
12-02-2016 06:33 PM