Learn Control
10-20-2010, 08:20 PM
#1
Senior Member
Thread Starter
Join Date: Jun 2008
Location: Cypress, CA
Posts: 305
Likes: 0
Received 1 Like
on
1 Post
Car: 1982+1988 Z28 Camaros
Engine: 1982=350 carb 1988=383 Carb
Transmission: 1982=4 speed T-10 1988=6 speed T56
Axle/Gears: 1982=stock
Learn Control
I have a flag in my $6E (Tunerpro v5) that allows the dash to display the Learn Control flag, either 'On' or 'Off'. It always stays 'off' also called 'disabled'
Does this mean my ECU is not 'learning,' and if so, what does that mean for me or my tune? I saw it flash 'on' once, but just for a millisecond. What values in the scalars or tables would possibly cause this to stay off? Car enters closed loop correctly if that matters
Does this mean my ECU is not 'learning,' and if so, what does that mean for me or my tune? I saw it flash 'on' once, but just for a millisecond. What values in the scalars or tables would possibly cause this to stay off? Car enters closed loop correctly if that matters
10-23-2010, 07:27 PM
#2
Senior Member
Thread Starter
Join Date: Jun 2008
Location: Cypress, CA
Posts: 305
Likes: 0
Received 1 Like
on
1 Post
Car: 1982+1988 Z28 Camaros
Engine: 1982=350 carb 1988=383 Carb
Transmission: 1982=4 speed T-10 1988=6 speed T56
Axle/Gears: 1982=stock
Re: Learn Control
Is this an extraordinarily dumb question? Can someone shed light on this issue for me?
10-23-2010, 08:12 PM
#3
Senior Member
Join Date: Oct 2009
Location: Pacific NW
Posts: 676
Likes: 0
Received 1 Like
on
1 Post
Car: 89 K3500 Fleetside
Engine: RAT *tbi* EBL
Transmission: TH400
Axle/Gears: 3.73-Dana 60
Re: Learn Control
If you see your blm's change than it is "learning" new long term settings.
I think it's just a quiet spell.
I think it's just a quiet spell.
Last edited by xch3no2; 10-23-2010 at 08:17 PM.
10-24-2010, 10:46 AM
#4
Senior Member
Thread Starter
Join Date: Jun 2008
Location: Cypress, CA
Posts: 305
Likes: 0
Received 1 Like
on
1 Post
Car: 1982+1988 Z28 Camaros
Engine: 1982=350 carb 1988=383 Carb
Transmission: 1982=4 speed T-10 1988=6 speed T56
Axle/Gears: 1982=stock
Re: Learn Control
Thank you, yes car enters closed loop, int and blms begin changing, however I guess that certain flag is faulty.. since it never changes to "learning."
10-27-2010, 07:01 PM
#5
Senior Member
Re: Learn Control
Aaaaa, yea, I have the same issue in my TP logs. Looking at the learn control bit flag, mostly stays "disabled". I checked and my BLMs/INT are changing. First made sure I wasnt in HM, so I would say something is up with that display flag.
Thread
Thread Starter
Forum
Replies
Last Post
Doobie52
Engine/Drivetrain/Suspension Parts for Sale
0
09-11-2015 06:19 PM
