where to get replacement wire harnesses/connectors?
03-05-2004, 06:44 PM
#1
Senior Member
Thread Starter
Join Date: Dec 2000
Location: Lutz, FL USA
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
where to get replacement wire harnesses/connectors?
i recently replaced my ignition coil, and when i pulled off the front wire harness/connector, the plastic was so dried and brittle that the clip (that holds it on) broke right off. this is a gray connector, two wire (i think one pink or red and one is yellow?) that connects to the front top of the coil. (91). i had it held in place with elec tape, but it starting coming loose and the tach was jumping all around, so i want to replace the connector.
where do you get replacement connectors like that??? thanks.
where do you get replacement connectors like that??? thanks.
03-06-2004, 09:30 AM
#3
TGO Supporter
Join Date: Sep 2003
Location: conway, s.c.
Posts: 6,127
Likes: 0
Received 8 Likes
on
8 Posts
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
Go to a junkyard and you can usually find one there. You can either cut the wires with it or use a pin extractor to remove the pins from the connector so you can replace it on your wire harness.
03-06-2004, 09:43 AM
#4
03-06-2004, 09:57 AM
#5
TGO Supporter
Join Date: Sep 2003
Location: conway, s.c.
Posts: 6,127
Likes: 0
Received 8 Likes
on
8 Posts
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
That is true sometimes, but I have managed to find some really nice connectors there. It also helps to look at some of the other GM cars there because the connectors are not specific to camaros and firebirds.
03-06-2004, 10:24 AM
#6
Supreme Member
Join Date: Jan 2002
Location: Bloomingdale,IL
Posts: 1,322
Likes: 0
Received 1 Like
on
1 Post
Car: 91 RS
Engine: 305 Tbi (L03)
Transmission: 700r4
Hehe your supposed to replace that when the clip breaks. Thats news to me. Mines been broke for about 2 years and i havent had any problems with it.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM
