Make power windows work in accessory too
#1
Supreme Member
Thread Starter
Join Date: Apr 2003
Location: Vancouver, BC
Posts: 1,111
Likes: 0
Received 0 Likes
on
0 Posts
Car: '86 Camaro SC, '16 QX60
Engine: 2.8 V6 POWER, 3.5L V6 N/A
Transmission: T-5, CVT
Make power windows work in accessory too
Has anyone done this? I can't see that it would be that hard. Add an extra wire probably. The only problem I usually run into with the fuse box is you can't pull it down very far. If anyone has done this or has any encouraging (or discouraging) comments, I'd like to hear them.
On a side note, why doesn't the search highlight the search words in red anymore?
On a side note, why doesn't the search highlight the search words in red anymore?
#2
TGO Supporter
Join Date: Sep 2003
Location: conway, s.c.
Posts: 6,127
Likes: 0
Received 8 Likes
on
8 Posts
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
It probably wouldn't be that hard to do. BTW, the fuse block can be dropped further by removing the two screws at the aft edge of it at the hinge.
#3
Supreme Member
Thread Starter
Join Date: Apr 2003
Location: Vancouver, BC
Posts: 1,111
Likes: 0
Received 0 Likes
on
0 Posts
Car: '86 Camaro SC, '16 QX60
Engine: 2.8 V6 POWER, 3.5L V6 N/A
Transmission: T-5, CVT
I've removed the two screws, but I still can't get it very far down because the wires won't allow it.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
IROCZDAVE (88-L98)
Interior Parts for Sale
4
10-06-2016 09:08 AM
IROCZDAVE (88-L98)
Interior Parts for Sale
0
08-06-2015 03:51 PM