Go Back   Third Generation F-Body Message Boards > Tech Boards > Electronics
Sign in using an external account
Register Forgot Password?

Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

Welcome to ThirdGen.org!
Welcome to ThirdGen.org.

You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!


Reply
 
Thread Tools Search this Thread
Old 01-31-2009, 02:50 PM   #1
Member
 
Join Date: Oct 2007
Location: North Liberty Ia
Posts: 466
Car: 89 Firebird
Engine: 2.8L out of a 89 camaro
Transmission: 5 speed
Axle/Gears: ?

Classifieds Rating: (0)
no power to pulldown unit

so ive done a bit of searching and not found the fuse for the pull down. im assuming its been cut out. since there are a few wires above the fuse block cut and taped. also. im trying to hook the switch up for the parking break. a tan wire. found a cut harness under the console.. 1 has power keyed on. not sure about the rest. orange gray and i think black. might be a 4th wire there not exactly sure. i just rebuilt the hatch motor with new guides and reinforced pice and new gear nut. adjusted far enough that the hatch locks. i am begining to dis like electrical gremlins.
enswrob is offline vBGarage Page   Reply With Quote
Old 01-31-2009, 06:41 PM   #2
Moderator
 
Join Date: Dec 1999
Location: Hacienda Heights, CA
Posts: 4,991
Car: 90 RS 'Vert, 88 IROC-Z, 88 Firebird
Engine: 305 ci tbi, 305 ci tpi, 350 ci tpi
Transmission: WC-T5, WC-T5, 700R4
Axle/Gears: 3.45, 3.27, 3.27

Classifieds Rating: (1)
Re: no power to pulldown unit

For your model year of Firebird the hatch pull-down fuse is not in the fuse panel. It is in a single fuse holder that was attached to the outside edge of the fuse panel. The hot wire coming from it is red with a white stripe. That fuse holder is slipped onto a dovetail on the outside edge of the panel. It can easily be slipped off, so if it isn't there you'll have to search under the dash near the fuse panel to locate it. It has a 15 amp fuse in it.

Lon
__________________
90 RS Convertible "cruiser"
88 Firebird Formula "racer"
88 Iroc-Z Resto-Project car "paperweight"

Owner: Top-Down Solutions

web site: www.Top-DownSolutions.com
lonsal is offline vBGarage Page   Reply With Quote
Old 01-31-2009, 06:50 PM   #3
Member
 
Join Date: Oct 2007
Location: North Liberty Ia
Posts: 466
Car: 89 Firebird
Engine: 2.8L out of a 89 camaro
Transmission: 5 speed
Axle/Gears: ?

Classifieds Rating: (0)
Re: no power to pulldown unit

ill have to look for the red wire w/white stripe tomarrow. i pulled the fuse panel down earlyer today and didn't see any fuse holders as up in the dash.
__________________



mods bosch III injectors
enswrob is offline vBGarage Page   Reply With Quote
Old 02-01-2009, 04:51 PM   #4
Member
 
Join Date: Oct 2007
Location: North Liberty Ia
Posts: 466
Car: 89 Firebird
Engine: 2.8L out of a 89 camaro
Transmission: 5 speed
Axle/Gears: ?

Classifieds Rating: (0)
Re: no power to pulldown unit

found the red wire with the white stripe under the dash. as suspected its cut. no inline fuse. guess ill have fun figureing out where the other part of the wire runs from the hatch up to the block. does it run up the drivers side or console area?
__________________



mods bosch III injectors
enswrob is offline vBGarage Page   Reply With Quote
Old 02-01-2009, 10:43 PM   #5
Moderator
 
Join Date: Dec 1999
Location: Hacienda Heights, CA
Posts: 4,991
Car: 90 RS 'Vert, 88 IROC-Z, 88 Firebird
Engine: 305 ci tbi, 305 ci tpi, 350 ci tpi
Transmission: WC-T5, WC-T5, 700R4
Axle/Gears: 3.45, 3.27, 3.27

Classifieds Rating: (1)
Re: no power to pulldown unit

Drivers side I think.

Lon
lonsal is offline vBGarage Page   Reply With Quote
Old 02-01-2009, 10:43 PM
ThirdGen
1992 Camaro




Paid Advertisement


Reply

Go Back   Third Generation F-Body Message Boards > Tech Boards > Electronics

Tags
firebird, fuse, inline, pull
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

 


1982 Camaro '82 || 1983 Camaro '83 || 1984 Camaro '84 || 1985 Camaro '85 || 1986 Camaro '86 || 1987 Camaro '87 || 1988 Camaro '88 || 1989 Camaro '89 || 1990 Camaro '90 || 1991 Camaro '91 || 1992 Camaro '92


All times are GMT -5. The time now is 11:19 AM.


Powered by vBulletin® Version 3.7.5
Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.5.2
All content copyright © 1997 - 2012 ThirdGen.org. All rights reserved. No part of this website may be reproduced without the expressed, documented, and written consent of ThirdGen.org's Administrators.

Emails & Contact Details