Radio interferance when fan is running
#1
Member
Thread Starter
iTrader: (1)
Join Date: Oct 2009
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
Radio interferance when fan is running
I've just become used to crappy radio reception since I replaced my antenna this summer, but I noticed something yesterday since It's cooling off and I was driving with no A/C on. When the fan is off, the radio interferance goes away! Where am I going to want to start looking to figure this one out?
#2
Supreme Member
Join Date: Jan 2006
Location: Mooresville NC
Posts: 3,341
Likes: 0
Received 10 Likes
on
10 Posts
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Radioactive
Make sure the antenna cable shield is grounded at both ends.
Then install a capacitor, at least 1,000 microfarads @ at least 20 volts.
They are available at electronics parts stores.
Wire the capacitor across the + and ground of the fan motor at the connector.
+ to power, ▬ to ground.
See if that reduces or eliminates the RFI.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Slamming The Wall Is Not The Neatest Way To Remove An Engine
.
Then install a capacitor, at least 1,000 microfarads @ at least 20 volts.
They are available at electronics parts stores.
Wire the capacitor across the + and ground of the fan motor at the connector.
+ to power, ▬ to ground.
See if that reduces or eliminates the RFI.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Slamming The Wall Is Not The Neatest Way To Remove An Engine
.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM