You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Well, I've tried to sell it a few times locally with each one falling through. This is the L98 out of my GTA. Since I have an LS1 going in, I no longer need it. It ran fine when I pulled it with the typical sbc smoke on startup, so a rebuild/freshening might be in order. Perfect for a low buck project car/truck.
I have the MAF, intake ducting and distributor/wires which were removed prior to the engine being pulled. I you have any questions don't be shy.
looking for $500 or best, pick up at my house as I don't have a truck to deliver this thing.
I have the ecm, it will go with the motor. The harness is being used for my swap though.
I have someone person who might be interested, but hasn't stepped up yet. I have a pallet that I can put it on, not sure how to secure it down yet, and an engine hoist to get it into a car/truck/van/trailer.
__________________ Steve
my rides:
Red '89 Trans Am GTA
Silver 05 WRX Wagon
can you provide complete engine serial # & eng code(looking for codes awk or awa)?where exactly are you located?i am in nw ind,about 20 min from portage ,in.
