heads and 350 rotating assembly for sale
#1
Member
Thread Starter
iTrader: (5)
Join Date: Jul 2005
Location: chesterfield, va
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 t/a gta
Engine: 383
Transmission: t-56
Axle/Gears: moser/auburn/410
heads and 350 rotating assembly for sale
i have four sets of heads for sale and a 350 rotating assembly.
double humps, casting number 3782461 $250
vortecs, casting number 10239906 $175
perimeter bolt 350, casting number 462624 $75
centerbolt 350, casting number 14102193 $75
86-95 350 one piece rear main block, rotating assembly. new crank, new bearings, new rings, used but in good condition rods and pistons. crank kit is worth $175. asking $250 obo
would rather not ship but willing to if buyer pays shipping. in richmond virginia area.
double humps, casting number 3782461 $250
vortecs, casting number 10239906 $175
perimeter bolt 350, casting number 462624 $75
centerbolt 350, casting number 14102193 $75
86-95 350 one piece rear main block, rotating assembly. new crank, new bearings, new rings, used but in good condition rods and pistons. crank kit is worth $175. asking $250 obo
would rather not ship but willing to if buyer pays shipping. in richmond virginia area.
#2
Junior Member
Join Date: Mar 2007
Location: Summerville, SC
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1971 Chevelle
Engine: 383
Transmission: TH350
Axle/Gears: 3.08 10 bolt, limited slip
Re: heads and 350 rotating assembly for sale
what size valves on the perimeter bolt 350 heads?
#4
Member
Thread Starter
iTrader: (5)
Join Date: Jul 2005
Location: chesterfield, va
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 t/a gta
Engine: 383
Transmission: t-56
Axle/Gears: moser/auburn/410
Re: heads and 350 rotating assembly for sale
valves on the heads are 1.94/1.5. ill get some pics of the vortecs for you tomorrow.
#7
Member
Re: heads and 350 rotating assembly for sale
what all has been done to the 461's?
Have they been to a machine shop recently?
How bout some pics? Of the runners and the valves.
Thanks
Have they been to a machine shop recently?
How bout some pics? Of the runners and the valves.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
mhatfield 14
Tech / General Engine
5
10-24-2015 07:48 AM
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM